ED Series Training Manual Distributed By: Commercial Refrigeration Service, Inc. WWW.IceCubes.NET WWW.CorneliusParts.
ED200 & ED250 MODELS ED200 ED250 ED300 200 lbs. 250 lbs. 300 lbs. 10 10 12 BC Model Only BC Model Only BC Model Only Voltage 120 120 120 Phase 1 1 1 Hertz 60 60 60 Amp Draw 3.5 3.5 5.
77 53 52 14 61 33 62 84 86 37 10 57 34 80 69 79 47 13 67 70 11 48 36 69 69 61 68 43 68 42 56 46 18 35 63 60 66 40 41 64 28 32 71 67 65 65 45 58 15 66 31 59 19 24 16 12 75 66 26 66 73 38 27 67 29 38 55 73 50 23 22 49 75 30 64 66 81 39 20 78 54 25 44 51 17 72 ENDURO 200 & ENDURO 250 TD 218 2 21 74
ENDURO 300 (ED300) (POST-MIX) 54 8 75 56 73 67 56 4 86 45 55 70 31 47 60 80 42 87 86 78 80 68 43 66 6 70 64 53 58 1 57 36 5 70 35 76 65 2 63 50 80 52 69 30 44 37 33 70 3 72 62 38 79 68 49 48 9 86 39 71 51 67 41 40 80 34 78 32 83 70 59 80 10 77 61 81 84 7 Item No. Part No. Item No. Name 1 21491 Slide, Gate 2 22081 Restrictor, Gate 3 27107 Bracket, Lever Depressor 4 15213 Agitator, Left 5 29483 Cover, Rear Part No.
ENDURO 200 & ENDURO 250 Item No. Part No. Item No.
1 14 12 15 23,27 25 2 3 10 24 17 10 24 5 25 22 8 22 7 24 13 26 28 11 24 4 16 6 9 18 FIGURE 1. ELECTRICAL BOX ASSEMBLY Item No. Part No. Item No. Name Part No.
ENDURO 300 (ED300) (POST-MIX) Item No. 29 Part No. 29509 30 Item No. Name Part No. Name Base Ass’y 60 52957 Hopper Ass’y Dispensing Valve Panel Ass’y 61 52967 Plug 31 15214 Agitator, Right 62 52972 Tab, Retaining 32 29562 Spacer, Drain 63 70016 Hex Nut, No. 10-32 33 29664 Lever, Ice Chute 64 70017 Insert, Nylon, No. 10-32 34 29667 Support, Product Lines 65 70056 Washer, Flat, No.
ENDURO 300 (ED300) (POST-MIX) Item No. Part No. Name 2 1 29303 Plate, Motor Mount 2 29654 Plate, Adjustable, Motor 3 30794 Heater, Motor 4 32498 Motor 5 51859 Seal, Motor Shaft 6 51860 Gasket, Motor 7 70018 Hex Nut, 1/4-20 8 70043 Washer, Flat, 1/4 9 70048 Washer, Lock, 1/4 10 70257 Screw, Phil Truss Hd, 1/4-20 By 1/2-In. Long 12 7 11 9 8 8 9 10 13 14 4 11 70260 Screw, Phil Rd. Hd., 1/4-20 By 1-In.
ENDURO 300 (ED300) (POST-MIX) 12 20 10 13 24 5 18 8 21 11 23 23 14 22 27 2 15 26 19 3 17 28 25 1 23 7 6 23 4 9 ELECTRICAL BOX ASSEMBLY Item No. Part No. Item No. Name Part No. Name 33352 Electrical Box and Reflector Ass’y 16 50458 Strain Relief 1 29494 Box, Electrical 17 50459 Bushing, Harness 2 30514 Clamp, Capacitor 18 50475 Bushing, Jumper 3 30774 Capacitor 19 70015 Hex Nut, No.
ENDURO 300 (ED300) (POST-MIX) 6 4 5 3 2 1 VALVE PANEL ASSEMBLY Item No. Part No. Item No. Name 29647 29648 29645 29646 29510 29539 Valve Panel Ass’y, 8 Corco Valve Panel Ass’y, 8 LEV Valve Panel Ass’y, 10 Corco Valve Panel Ass’y, 10LEV Valve Panel Ass’y, 12 Corco Valve Panel Ass’y, 12LEV 1 29316 Manifold Ass’y, 2-Flavor 2 29317 Manifold Ass’y, 1-Flavor 3 29315 Manifold Ass’y, 3-Flavor Distributed By: Commercial Refrigeration Service, Inc. WWW.IceCubes.NET WWW.CorneliusParts.
TD 218 10 FIGURE 2.
TD 218 11 FIGURE 3.
TD 218 12 S2 W1 W2 W3 3 W4 4 S6 S5 W5 6 W6 W7 7 W8 W1 2 W2 W3 W5 W4 3 4 S5 S4 S3 5 S8 S7 6 S6 7 W7 W6 8 W8 W9 9 W10 1 2 3 4 5 6 7 8 9 Valves as viewed from the front of the dispenser 10 S8 11 12 S10 S9 Coldplate 10 S7 Coldplate 8 Syrup Inlets are 1/4I Barb.
TD 218 13 B L U E B L U E GATE SOLEĆ NOID (106VD C) WB HL I U T E E OPTIONAL WHITE BLACK WB H L I A T C E K Q.C.
REMOVAL AND REPLACEMENT OF AGITATORS Agitator Disk, L.H., With Center Hole Thumb Screw Agitator Disk, R.H., With 2 Retain Left Front View Valve Side Top of Dispenser 92089 TO REMOVE LEFT, CCW AGITATOR 1. Remove center thumb screw by turning it counterclockwise. 2. Lift plastic agitator disk off of stainless steel agitator. 3. Grip agitation arms at the center and lift up. 4. Replace by reversing steps. TO REMOVE RIGHT, CW AGITATOR 1. Remove the (2) retaining pins. 2.
TD 218 15 BLK BEVERAGE FAUCET (TYPICAL) TRANSFORMER BLK MOTOR HEATER BEVERAGE SYSTEM 24 V. WHT LIGHT WHT BLK 2 KEY SWITCH OPTION 1 T'STAT ICE LEVEL SIGNAL OPTION TERMINAL BOARD WHT WHT L RED BLK DISPENSE SWITCH RED AC WHT WHT CAPACITOR RED BLU BLK WHT ORN WHT BLK PNK BLK CCW AGITATOR MOTOR Q.C.
