Technical information

Installation Instruction for all Models of Drop-In and Free Standing Ice Cooled Dispensers

ADJUST WATER-TO-SYRUP RATIO

Separator

Water-To-Syrup

ratio cup

Figure 1.

1. Remove valve cover and install syrup separator over the diffuser and through the nozzle.

2. Hold cup under valve and dispense beverage for a specific time (i.e. 2 seconds).

NOTE:Water and syrup must be cold before checking ratios.

3. Adjust carbonated water flow to the desired rate (such as 90 to 110 ml (3 to 3.75 oz.) per second).

4. Turn the flow adjuster 1/4 of a turn at a time and recheck the flow. To increase reading turn clockwise.

5. Set syrup flow adjuster to get the desired ratio.

6. Test the valve and adjust until a consistent ratio is delivered three consecutive times.

7. Repeat procedure for other valves

Valve Type

Manufacturer Maximum Operating Pressure

Portion Control

Cornelius 130 psi

Flowmatic 100 psi

Pushbutton

Cornelius 130 psi

Flowmatic 100 psi

Lever Type

Cornelius 130 psi

Flowmatic 100 psi

Autofill Lever

Cornelius 130 psi

Flowmatic 100 psi

Non-Electric

Cornelius 130 psi