Owner`s manual

5 630460082
INITIAL START UP, CHECKS AND ADJUSTMENT INSTRUCTIONS
NOTE: Do not start the Unit before completing the previous Installation steps.
Turn on the water supply and main power switch (located on top of the electrical box).
NOTE: If the Unit will not start, be sure the water reservoir is full. The low water safety control must be
properly adjusted to start and shut down the Unit. If the water level drops below the bottom of the res-
ervoir, the Unit must shut down. Adjustment is made by moving the magnet up or down.
FIGURE 1. FLOAT ADJUSTMENT
Water Level Control Adjustment – If necessary, adjust the float by bending the float arm up or down as need-
ed. Push the float assembly down until the Unit stops running. Release the float and the Unit will restart. Keep
water in the reservoir at the level line while the Unit is in operation (See Figure 1).
Low Water Safety Control – Adjust the magnet by bending the magnet arm as shown in Figure 1 to shut down
the Unit if the water level drops below the line on the side of the reservoir.
Bin Control – Remove four clips from top of the bin cover and lift cover so the bin control switch can be manu-
ally lifted until the Unit shuts down. Release the plate and unit will restart
Dispense Switch and Mechanism – By depressing the dispense switch, the dispense mechanism door on the
storage bin will open, and the agitator will rotate counterclockwise.
NOTE: If any of these checks or adjustments cannot be achieved, refer to Troubleshooting Section of
this manual or call our Technical Support Center for assistance.