Owner`s manual

630460082

If no continuity on start or run winding test, replace stator. If continuity on grounded motor test, replace stator.

INSTALLATION AND SHAFT SEAL REPLACEMENT

(See Figure 5)

1. Place shaft seal locator seat over gear motor output shaft, embossed side down, and push down until shaft

seal seat rests flush on top of gear motor.

2. Place rubber coated ceramic seal (important: ceramic face up) over output shaft and push down until seal

rests on top of the shaft seal seat. (Lubricate rubber on ceramic seal with [#06195] rubber lubricant.)

3. Place shaft seal with carbon face down(spring up) over output shaft and push (gently) downward until seal

rests on carbon face of the output shaft seal.

4. Push down on the washer compressing the spring on the output shaft seal. While holding the seals (down)

in place slide the E–ring into the groove on the output shaft.

FIGURE 5. SHAFT SEAL REPLACEMENT

FIGURE 6. EXTRUDING HEAD

FIGURE 7. AUGER

E–RING

WASHER, PLAIN FLAT

SHAFT SEAL

MOUNT, SHAFT SEAL

SEAT, SHAFT SEAL

GEARMOTOR

BEARING DELRIN

ANTI–ROTATION

RIB– 3 PLACES

AUGER NUT

BEARING NYLON

GROOVE

EXTRUDING

HEAD

AUGER

“D” DRIVE