Owner`s manual

8630460082
TO REPLACE WATER LEVEL CONTROL
1. Shut off the water supply. Shut off the main power switch or unplug the Ice Maker from electrical outlet.
2. Remove flexible tubing from bottom of the water level control, then drain water from the water level control
and evaporator.
3. Remove flexible tubing at bottom of the water level bowl connected to the overflow.
4. Hold water inlet fitting with proper tool to prevent it from rotating when disconnecting the water inlet.
5. Remove wing nut holding the water control to its mounting bracket. The control can be removed by lifting it
straight up.
TO REPLACE WATER LEVEL SAFETY SWITCH
1. Shut off main power switch or unplug the Ice Maker from electrical outlet.
2. Unplug Molex connector connecting switch to the electrical box.
3. Remove two screws anchoring the water level safety switch to the bottom of the water level control mount-
ing bracket.
ICE LEVEL CONTROL
The ice level control assembly is secured to the top of the ice storage container cover. When the switch
assembly is down, due to lack of ice in the ice storage container, an electrical impulse is sent to the compressor
to start the ice making cycle. As ice level increases in the ice storage container, the switch assembly is pushed
back. When the ice storage container is full, it de-actuates the switch which stops the compressor and the ice
making cycle.