Service manual

Lipton Brewed Iced Tea Training, Installation, & Service Manual

May 7, 2002 - 45 630460171

EXCESSIVE BURPING (CON-

STANT DISCHARGE FROM

BURP TUBE)

• Temperature too high. • Re-adjust thermostat (see no Hot

water).

WATER IN BOTTOM OF

BREWER

• Examine for leaks.

• Air ejector leaking.

• Repair or replace leaking component.

• Repair or replace.

• Check to see that the ball in the air

ejector is not stuck. If the ball is

stuck, homogeneity problems will

result. One symptom of the ball

being stuck can be air pockets going

out through the dispense nozzle.

• The fitting should be finger tight only.

WATER UNDER BREWER • Water temperature too high. • Measure and adjust as necessary.

• Unit will shut off heater relay if water

temperature exceeds 192

°F. A high

temperature message will appear on

the data mode screen. To turn the

heater relay back on (two things are

required), first the tank temperature

must drop below 192°F and then the

operator needs to press Run to put the

unit back into operation (See advi-

sory).

CLOUDY TEA • Air injector not venting.

• Low brewing temperature.

• Exceeding capacity of unit.