Service manual

Lipton Brewed Iced Tea Training, Installation, & Service Manual
May 7, 2002 - 37 630460171
FIGURE 7
5. Remove the old pump tube from the pump body. If the roller assembly
comes out with the tubing, place it back into the pump housing being
sure to align the roller assembly shaft keyway to the motor shaft so that
the two interlock.
6. Firmly press the new hose into the pump body around the roller assem-
bly, being sure to keep the protruding ends even with each other.
FIGURE 8
7. Once the tubing is in place, hold the tubing with one hand, capture the
lower part of the tubing with the outer housing, then proceed to capture
the shaft of the roller assembly and push the rear pump housing into
place. Make sure to capture the tubing within the body and not pinch it
between the halves. Do not use any tool other than your finger tips to
manipulate the tubing into the housing or you may damage the tube.
8. While holding the pump halves together with your hand, reinsert the
four thumb screws and tighten using a criss-cross pattern as shown. The
thumb screws should be tightened about ¼ turn beyond snug.