Service manual

Lipton Brewed Iced Tea Training, Installation, & Service Manual
630460171 - 16 May 7, 2002
• The bimetallic thermostat mounted on the heater tank acts as a
redundant shut-off control in the event of a malfunction of the
heater relay.
• Water Valves
• Inlet and outlet water valves to the hot water tank are activated
simultaneously to initiate flow of hot water.
• Sweetener Valve
• The sweetener valve is activated to initiate flow of sweetener
(unless deactivated during installation).
• Error Light
• Flashing red LED is activated in the event of an error.
CAPACITIES
Environmental Specifications
This brewer is intended for indoor installation only
Operating Temperature Range 60° F. to 110° F. (10°C - 38°C)
Storage Temperature Range 40° F. to 130° F (4°C - 54°C)
Electrical Requirement 15 amp
Water Inlet Size 3/8-inch (0.95 cm)
Water Flow Rate 2.5-ounce/second (74 ml/sec) one spigot open
5.0-ounce/second (148 ml/sec) two spigots open
Water Pressure Flowing 35psi (2.41 bar) (minimum) - 80 psi (5.52 bar) (maximum)
Note: If water filter is installed, the 35psi flowing pressure must be
maintained on the outlet side of the filter.
TABLE 1.
Dimensions and Weight Double Spigot
Counter must be level and capable of supporting
brewer weights
Height above counter 27.75 inches (70.5 cm)
Width 16.25 inches (41.3 cm)
Depth 15.00 inches (38 cm)
Shipping weight (approx) 64 lbs.