Service manual

560001279SER

‘‘SYRUP PRIME’’ SWITCHES

The ‘‘SYRUP PRIME’’ switches, located on the control panel, are touch-type switches and require only pressing

to activate. The ‘‘SYRUP PRIME’’ switches are used only when filling the syrup systems sold-out floats during

syrup replenishing, syrup flavor changeover, or sanitizing the syrup systems.

‘‘BLEND ON/OFF’’ SWITCHES

The ‘‘BLEND ON/OFF” switches, located on the control panel, are touch-type switches and require only

pressing to activate. These switches are used to fill the product blender tanks after the sold-out floats have

been filled using the ‘‘SYRUP PRIME’’ switches. After the product blender tanks have been filled, the “BLEND

ON/OFF” switches may be pressed again to prevent more product from entering the product blender tanks

during BRIX test. The “ON” and “BLEND ON/OFF” switches must be pressed to operate the freeze cylinders

beaters and refrigeration system during normal operation.

‘‘MOTOR’’ SWITCHES

The ‘‘MOTOR’’ switches, located on the control panel, are touch-type switches and require only pressing to

activate. These switches are used to operate the freeze cylinders beaters with no refrigeration during sanitizing.

“ON’’ SWITCHES

The ‘‘ON’’ switches, located on the control panel, are touch-type switches and require only pressing to activate.

These switches are used to operate the freeze cylinders beaters and refrigeration system after cylinders have

been filled with product. The freeze cylinders beaters and refrigeration system may be stopped by pressing the

‘‘OFF’’ switches.

‘‘OFF’’ SWITCHES

The ‘‘OFF’’ switches, located on the control panel, are touch-type switches and require only pressing to activate.

These switches are used to stop freeze cylinders beaters and refrigeration system.

‘‘ERROR RESET’’ SWITCH

‘‘ERROR RESET’’ switch, located on the control panel, is a touch-type switch and requires only pressing to

activate. The ‘‘ERROR RESET’’ switch is used to restore normal operation after error within Unit (indicated by

‘‘ERROR 1’’ or ‘‘ERROR 2’’ on message display) has been corrected.