Service manual

0713
26
1. Fully close (clockwise) CO
2
cylinder valve.
2. Slowly loosen CO
2
regulator assembly coupling
nut allowing CO
2
pressure to escape, then
remove regulator assembly from empty CO
2
cylinder.
3. Unfasten safety chain and remove empty CO
2
cylinder.
WARNING: To avoid personal injury
and/or property damage, always secure
CO
2
cylinder with safety chain to prevent if from
falling over. Should the valve become acciden-
tally damaged or broken off, CO
2
cylinder can
cause serious personal injury.
4. Position CO
2
cylinder and secure with safety
chain.
5. Make sure gasket is in place inside CO
2
regulator coupling nut, then install regulator on
CO
2
cylinder.
6. Open (counterclockwise) CO
2
cylinder valve
slightly to allow lines to slowly fill with gas, then
open valve fully to backseat valve.
(Backseating valve prevents leakage around
valve shaft).
7. Check CO
2
connections for leaks. Tighten loose
connections.
REPLENISHING SYRUP SUPPLY
WARNING: To avoid personal injury or
property damage, do not attempt to re-
move syrup tank cover until CO
2
pressure has
been released from tank.
1. Remove CO
2
disconnect and syrup disconnect
from empty syrup tank, then remove tank.
2. Place full syrup tank in position, then connect
CO
2
disconnect and syrup disconnect to full
syrup tank.
SYRUP FLAVOR CHANGE
Sanitize applicable syrup system as instructed, then
install full tank of new flavor syrup.