Unit installation

3
1
2
0
2
2
0
0
0
9
INSTALLATION
This section covers unpacking and inspection, selecting location, installing the Cooling Unit, preparing for
operation, and operation.
UNPACKING AND INSPECTION
NOTE: The Cooling Unit was thoroughly inspected before leaving the factory and the carrier has
accepted and signed for it. Any damage or irregularities should be noted at time of delivery (or not later
than 15 days from date of delivery) and immediately reported to the delivering carrier. Request a written
inspection report from Claims Inspector to substantiate any necessary claim. File claim with the
delivering carrier, not with IMI Cornelius Inc.
1. After Cooling Unit has been unpacked, remove shipping tape and other packing material.
2. Unpack LOOSE-SHIPPED PARTS. Make sure all items are present and in good condition.
Table 2. Loose-Shipped Parts
Item
No. Part No. Name Qty.
1 309852000 Tubing Clamp 24
2 770407 Barbed Connector, 1/4 by 3/8 12
3 770424 Barbed Connector, 1/2 by 1/2 2
4 311962000 Label, Line Identification 1
NOTE: The following Remote Condenser Coil and Fan Assembly and Refrigeration Lines Kits are
recommended for use with Cooling Units (Part numbers 4004 and 4005). Refrigeration Lines Kit (as
ordered) is used to connect the Remote Condenser Coil and Fan Assembly to the Cooling Unit.
5 4000 Remote Condenser Coil and Fan Ass’y 1
6 301115025 Refrigeration Line Kit, 25-ft. long, 90° 1
301115050 Refrigeration Line Kit, 50-ft. long, 90° 1
IDENTIFICATION OF LOOSE-SHIPPED PARTS
1. BARBED CONNECTORS (item 2) used to connect Cooling Unit outlet lines to insulated python lines.
Connections are secured with TUBING CLAMPS (item 1).
2. BARBED CONNECTORS (item 3) are used to connect Cooling Unit outlet carbonated water lines to
insulated python lines.
3. LABEL, LINE IDENTIFICATION (item 4) to be installed on Cooling Unit and syrup flavors to be recorded in
proper spaces on label.
4. REFRIGERATION LINE KIT (items 6) is used to connect REMOTE CONDENSER COIL AND FAN ASS’Y
(item 5) to Cooling Unit.
SELECTING LOCATION
COOLING UNIT
CAUTION: This Unit is intended for indoor installation only. Do not install this Unit in an
outdoor environment which would expose it to the outside elements.