Owner`s manual

20
all devices are listed, skip this section. If a device is
missing:
• Make sure all computers has one only
active network slot
• Make sure the Corinex Powernet USB
Adapters are plugged straight into the
wall and not through a power strip or
extension cord.
• The devices may be programmed with
different passwords. Setup all devices
with a new password as described in the
PowerNet Setup Tool Manual.
• The chosen outlet pair may have poor
electrical connection, try a different pair
of outlets.
4. Check that the Corinex Powernet USB Adapters
devices are detected by TCP/IP.
From the command prompt, run ping and type the
computer name or IP address of the computer you
are working on. [ping yourcomputername] This
should return 4 good packets. Now try to ping
another computer on the network. If a timeout
occurs:
• Go into the TCP/IP properties and check that
the buttons for automatically obtaining IP
address and gateway are checked. If not,
make sure that both computers are on the
same subnet.
• Run ipconfig/all from the command prompt
on all computers to verify that all computers
have valid IP addresses on the same subnet
• The IP tables may be corrupted, reboot all
computers and try again.