Technical data

Installation Guide

Corinex AV200 CableLAN Adapter

2.6 Installing the AV200 CableLAN Adapter

To connect the Corinex AV200 CableLAN Adapter to your computer, follow the steps

listed below.

1. Connect the supplied Ethernet cable to the LAN port on the adapter and to

an Ethernet port on your computer.

2. Connect the power cable to the adapter and the other

end into any AC electrical outlet.

3. Connect the coaxial cable to the adapter and to any coaxial plug

Note: Please use a straight-forward Ethernet cable for connection of the

AV200 CableLAN Adapter to your computer. If you are connecting the

AV200 CableLAN Adapter to a modem or switch, please use a crossover

cable.

2.7 Testing the Setup

To verify that your equipment is connected and working correctly, use the standard

Ping utility. In Windows, click on menu Start -> Run, then write the command

ping IPADDRESS -t, where IPADDRESS is the IP address of the computer to

which the AV200 CableLAN Adapter is connected, e.g. ping 192.168.4.1 -t (this

process can be interrupted by pressing CTRL+C).

1. Ping the IP address of the computer to which the AV200 CableLAN Adapter is

connected. If this fails, there is a problem with the Ethernet network card or

with the TCP/IP protocol.

2. Repeat the same process with the other computers on your AV200

CableLAN network.

3. If all the computers can ping themselves, try pinging another computer on

your AV200 CableLAN network. If this fails, then there is a problem with the

connection across your AV200 CableLAN network or with the configuration of

the AV200 CableLAN Adapters. Check the connection to the coax plug, or try a

different jack. Verify the configuration of the AV200 CableLAN Adapters,

especially the network number, as only adapters in the same network can see

each other. Please see chapter 3 for details on configuration.

If you experience any problems with your setup, try unplugging the AV200 CableLAN

Adapter and restarting the computer, as this sometimes fixes the problem. If the

problem persists, please refer to the troubleshooting guide at the end of this

manual.