Technical data

Web Configuration

Corinex AV200 CableLAN Adapter

3.3.6 MAC and PHY Configuration

The following settings are in regards to the type of network you want to set up. The

Corinex AV200 CableLAN Adapter supports two different types of networks:

P2P and

In-Home AV (MAC Type checkbox). Chapter 4 contains more information about

the types of network setups.

Note: The user is strongly recommended to use the In-home AV mode

as this can significantly increase the performance and security. We cannot

guarantee the presence of the P2P mode in the future versions of the AV200

firmware.

Regardless of which type of network you choose, the spectral notches must be

either enabled or disabled (Transmission Mode

selector). If the adapter is running

in an environment where it can cause interference to a HAM radio receiver, the

option of spectral masking can be enabled. When this option, called 2-32 MHz with

Notches, is enabled, it blocks the CableLAN signal entirely from the frequency

bands used by HAM radio.

When using an In-Home AV network, further configuration is possible. An adapter

can be defined as either an Access Point (AP) or an End Point (EP) (Node Type

field).