Technical data

11
Web Configuration
Corinex AV200 CableLAN Adapter
3.3 Change Configuration Page
3.3.1 Overview
This configuration page lets you set some of the adapter’s basic options. Any settings
changed here will be stored in the adapter’s permanent memory and loaded and
configured automatically as soon as the adapter is restarted. Changing these settings
also takes effect immediately, with the exception of a few particular options.
Notes:
• A different IP must be set for each adapter that will operate on the
same network. An adapter’s IP does not need to be in the same range as
the devices or PCs communicating with the adapters. Only while
accessing the configuration page, a PC must have the same address range
as the adapter (10.10.X.X and Netmask 255.255.0.0 in the default
state).
• The adapter’s netmask can also be changed, for example to a type C
(255.255.255.0) if necessary. This is a more advanced option, which you
may ignore if you’re not familiar with it.
• If the adapter is going to be accessed through a router (for example in a
large office network), the gateway IP needs to be configured. Otherwise,
it can be ignored.
THE IP CHANGE IN THE ADAPTERS WILL BE EFFECTIVE ONLY AFTER A
RESTART OR A REBOOT. IT MAY BE A GOOD IDEA TO PLACE A LABEL ON
EACH ADAPTER WITH ITS IP ADDRESS, SO YOU DON’T LOSE THE ABILITY
TO ACCESS IT.