Technical data

Web Configuration

Corinex AV200 CableLAN Adapter

3 Web Configuration

In order to access the web configuration pages, it is necessary to know the adapter’s

IP address and to be connected to it (e.g. through an Ethernet cable). Adapters that

have not previously been configured have the IP address 10.10.1.69. Open a web

browser (Microsoft Internet Explorer v6.0, Mozilla v1.7.2 and Mozilla Firefox v1.0

have been verified for use with these products.), and type the IP address in the

address bar – the URL should be http://10.10.1.69/ unless you are not setting it up

for the first time, and you have previously changed it to something else.

Changing the default IP address, 10.10.1.69, is required to allow access to an

adapter when two or more units are active on the same network. The IP address

is a device’s unique identifier on a network, so the adapters would not be able

to tell each other apart if they had the same identity, just as a postman wouldn’t

know which house to deliver to, if two neighbors in a large city had the same street

number. Follow the steps below to configure a new IP address for each adapter:

1. In your computer’s network settings, enter an address in the range 10.10.

X.X and the netmask 255.255.0.0. This is necessary in order to be compatible

with the adapter’s default settings. For details on how to set up an IP address

in your computer, please see chapter 5.

2. Plug in your AV200 CableLAN Adapter and connect it to the PC via the supplied

Ethernet cable.

3. Open the Web browser and type the following URL: http://10.10.1.69. You

will get to the configuration web interface of the AV200 CableLAN Adapter.

3.1 Authentication Page

If the configuration password is enabled, you’ll need to login before you can access

the web pages where you make changes to the network. Therefore, you will first

be taken to an Authentication page, where you will need to enter either the

configuration password – to access these web pages or a factory reset password

– in order to set the configuration to a default value. The embedded web server

has an authentication timeout of 5 minutes; i.e. if no web pages are loaded within 5

minutes, the login expires and you will need to login again.

Note: The default password for accessing the configuration is “paterna”.

The default password for resetting the adapter into default settings is

“betera”.