User's Manual

38 Using Your Projector
NOTE: OSD warning messages - low battery
The Low Battery warning message pops up when the battery voltage is lower
than 2V. At this condition, the pen still can work about 1~2 hours.
The pen will be disabled when the battery voltage is lower than 1.8V.
NOTE: OSD warning messages - out of range
The situations below may cause the pen sensor out of range:
The pen sensor doesn't face the screen.
The pen is too far away from the screen.
The projector brightness is too low for detection.
NOTE: Combinations of buttons
Left + Function:
The Pen Information menu appears on the screen.
Right + Function:
The Set Function menu appears on the screen. Use
Left/Right to move up/down and use Function to enter/apply.
When Toggle is selected in the Set Function menu, press the Function
button to select Normal/Draw/Stable mode.
3 Function Acts as the function which is defined through the
Set Function option on the Interactive menu
(see page 63).
NOTE: To undo a function, double click the
Function button.
4 LED indicators Two LED indicators are available: Green and
Amber (see on "Interactive Pen LED Guiding
Signals" on page 110).
5 Right Acts as a mouse right button.
6 Reset Press to reset the interactive pen configuration.