Specsheet

COREtec PRO Molding Sheet 2
Installation Instructions
Quarter Round - this creates the nishing touches between the oor and baseboards.
T-Molding - A T-shaped transition piece that covers the narrow gap in a doorway between two ad-
jacent oors that are on the same level.
Baby Threshold - this is used to transition from hard surface oors to oors of a dierent height
level.
Overlap Reducer - this is used to transition from a higher-prole oor to a lower-prole oor.
Stair Cap - this is used when installing COREtec on stairs, providing a capped edge and nishing
touch on the stair edge.
Flush Stair Nose - this is used when installing COREtec on stairs, providing the nishing touch to
the outside stair edge.
Measure & trim to t.
Ax molding using adhesive, screws or nails.
Follow adhesive manufacturer’s instructions completely.
Measure & trim to t.
Ax molding using adhesive, screws or nails.
Insert molding into track. Tap down with rubber mallet.
Measure & trim to t.
Ax molding using adhesive, screws or nails.
Follow adhesive manufacturer’s instructions completely.
Measure & trim to t.
Ax molding using adhesive, screws or nails.
Insert molding into track. Tap down with rubber mallet.
Measure & trim to t.
Ax molding to stair edge using adhesive.
Follow adhesive manufacturer’s instructions completely.
Measure & trim to t.
Ax molding to stair edge using adhesive.
Follow adhesive manufacturer’s instructions completely.