User Manual

6
XD730.400 Piezo Objective Scanner User Manual
Installation steps of XD730.400, as follows:
1. Screw the corresponding objective lens into the XD730.400 and tighten
2. Screw the lens into the adapter and tighten
3. Fix the installed piezo objective scanner and microscope connection section
Lens adapter
Fixed connection(M3)
Note:
During the installation process, please pay attention to handle, so as not to damage
the XD730.400 piezo objective scanner or scratch and wear it.
When connecting XD730.400, it is required that the weight of the objective lens does
not exceed the maximum allowable load of XD730.400.
The connection method of the LEMO connector is shown in the following figure:
Sensor output
Label for sensor output
Label for PZT drive
PZT drive output