User Manual

Linear Piezo Nanopositioning Stage User Manual
6
5.2 Load
When installing the load, ensure that the load mass is less than the max load of piezo
stage, and install the load as much as possible at the center of the moving surface.
The correct placement of the load is shown below:
Load applied to the center of piezo stage
Try not to let the load center of gravity exceed piezo stage
For protection, we don't recommend the load is too high. If it is used a higher load, please
reduce the position center of the load gravity.
The error placement method is as follows:
It is forbidden to load the load on one side of the piezo stage, which would cause serious
damage to the product, as shown in the following figure: