User Manual

S22 Piezo Tip/tilt Platform User Manual
10
5.2 Load
When installing the load, ensure that the load mass is less than the max load of the S22,
and install the load as much as possible at the center of the moving surface.
The correct placement of the load is shown below:
Figure7. Load applied to the center of the stage
Figure8. Try not to let the load center of gravity exceed the stage
Figure9. Do not load longer loads and add to the side of the piezo stage
It is forbidden to load the load on one side of the piezo stage, which would cause serious
damage to the product, as shown in the following figure:
For protection, we don't recommend the load is too high. If it is used a higher load, please
reduce the position center of the load gravity. The error placement method is as follows: