User Manual

P92.X40 Fast Tool Positioning Stage User Manual

5. Installation and operation

Safety check should be carried out before installation, such as whether the connection wire

is damaged or broken, whether the drive power supply is grounded, etc.

5.1 Installation and connection

1.Ensure that the installation plane is relatively flat;

2.use M6 screws to mount P92.X40 and tighten.

3.Mounting the load and tighten it properly to ensure the positioning accuracy.

4.Connect the P92.X40 connector with the corresponding controller according to the

identification.

The wiring mode of Lemo connector is shown as below:

FIG.2 Connector diagram

Sensor output

Label for sensor output

Label for PZT drive

PZT drive output