User Manual

6
P92.X25 Fast Tool Positioning Stage User Manual
5.2 Load
When mounting the load, ensure that the load weight is less than the maximum load
capacity of P92.X25, and try to mount the load in the center of the moving surface. The
two screws should be tightened, so as not to affect the dynamic characteristics of the fast
tool.
The correct position to mount the load is shown below:
Fast tool(sample)
Notice:
When mounting the load, tighten the load slowly. The torque should not be too
large to prevent damage to the mechanism.
Avoid stretching and bending cables.
Use the dedicated cable provided by CoreMorrow to connect P92.X25 and the
controller.
Do not connect via an extension cable casually, if you need a longer cable, please
contact CoreMorrow.
5.3 Operating
Please reconfirm the following information before turning on the power:
Operating environment meets the operating environment requirements of P92.X25.
Fixed screws must be tightened.