User Manual

10
P76 Piezo Objective Scanner User Manual
Internal structure of the P76 is maintenance-free. Please do not loosen the screws on the
product structure to avoid affecting the accuracy of the product.
Daily cleaning:
Please separate the product from the controller before cleaning the product surface.
When cleaning, first use a towel dipped in a small amount of detergent to gently wipe the
surface of the product, and then clean it with alcohol. Do not use ultrasonic cleaning.
When cleaning the surface, try not to pick up the product. If you must pick it up, it is better
to place a sponge under the product for protection. The product should not be too high
away from the sponge to prevent the product from being unstable and falling off.
8. Connector
Figure6. 1-contact LEMO
8.1 Driving and Sensor cable
Driving cable interface is 1-contact LEMO, model number is LEMO ERA.00.250.CTL, as
shown below:
Figure7. 4-contacts LEMO
Sensor cable interface is 4-contacts LEMO, model number is LEMO ERA.0S.304.CLL, as
shown below: