User Manual

8
P76 Piezo Objective Scanner User Manual
When connecting the objective lens, pay attention that the quality of the objective lens
does not exceed the maximum allowable load of P76, and the load is not too long,
otherwise it is easy to cause oscillation and damage P76.
5.3 Operating
Please confirm the following information before starting the power supply:
The environment meets requirements of P76 working environment;
The fixing screws must be tightened;
The above information is determined to perform controller related operations:
1、Please carefully read piezo controller user manual before operating, then start the
controller;
2、Set the piezo controller to zero;
3、After checking for no abnormalities, input voltage values according to requirements
(keyboard or analog control);
4、It could work normally within the rated voltage range of piezo ceramic (0~120V, max
not exceeding 150V);
5、Please set the piezo controller to zero after used.
Please do not touch the product during the operation, avoid affecting the piezo scanner
performance or even damage the piezo scanner.
The resolution of piezo ceramic is not limited. It depends on the performance of piezo
controller. In order to better achieve the motion accuracy, it is recommended to use
CoreMorrow piezo controller. For the operation of piezo controller, please refer to piezo
controller usual manual.
6.1 Transportation
Piezo Obejctive scanner is packed in carton. The transportation is carried out under
the condition of packaging. This product can be transported by various means of
transportation under normal conditions. During transportation, it should avoid direct rain
and snow, avoid contact with corrosive substances, and avoid strong collision, try to avoid
6. Transportation and inspection