N31 Linear Piezo Motor User Manual Version: V1.0 This document describes the following products: ■ N31.25E N31.25K ■ N31.50E N31.50K ■ N31.100E N31.
DECLARATION Thank you for choosing Coremorrow's products! This user manual is applicable to N31 Linear Piezo Motor. For your smooth and correct use of this product, please read this manual carefully before use. Please follow the instructions in the manual installation and use procedures. Improper operation may cause injury to the operator or damage to the product.
Contents 1. Introduction ........................................................................................................................................2 1.1 Purpose and content ................................................................................................................2 1.2 Symbol and meaning................................................................................................................2 1.3 Expected reader .......................................................
N31 Linear Piezo Motor User Manual 1. Introduction 1.1 Purpose and content The manual is mainly for your smooth and correct use of piezo motor. The manual contains all necessary information for N31 linear piezo motor. The manual describes the precautions during installation and use. 1.2 Symbol and meaning DANGER: Improper handling may could cause injury to the operator. Attention: Improper handling can cause damage to the equipment. No order between items. 1. 2. Please operating in order. 1.
2. Safety Guide N31 linear piezo motor is designed with advanced technology and safety standards, for safety and proper use of the product, please pay attention to following points when using: Temperature changed and pressure will charge the piezo motor.
N31 Linear Piezo Motor User Manual 3. Product Overview 3.1 Characteristics Large blocking force Automatic zero position after power-on Optional grating sensor Optional 2 or 3 axes Wear-resistant material Vacuum non-magnetic compatible Closed-loop automatic return after accidental touch 3.2 Motion Direction Motion direction of N31 4.
5. Installation and Operation Before installation, first check the safety, such as whether the cable is damaged or broken, and whether the power supply has grounding protection. 5.1 Installation and announcement 1. Ensure that the installation plane is relatively flat. 2. Fix the platform with M3 screws and tighten it. 3. Install load, properly tighten, load should not exceed 5kg. N31 installation diagram is shown below: Travel mechanism Fixed mounting (M3) Load connection(M4) Load connection(M2.
N31 Linear Piezo Motor User Manual For protection, we don't recommend the load is too high. If it is used a higher load, please reduce the position center of the load gravity.
Correct connection Please do not connect as shown below: Incorrect connection Note: Slowly tighten the load when installing it, and the torque should not be too large to avoid damage to mechanism. Avoid stretching and bending cables. Please connect N31 and controller with special cable provided by CoreMorrow. Please do not extend the cable without authorization, please contact us if you need a longer cable.
N31 Linear Piezo Motor User Manual 5.3 Operating Please confirm the following information before starting the power supply: The environment meets requirements of N31 operating environment; The fixing screws must be tightened; The above information is determined to perform controller related operations: 1. Please carefully read piezo controller user manual before operating, then start the controller; 2. Set the piezo controller to zero; 3.
Whether the product identification is clear and complete; Whether the connector is loose, the connection line is broken or not, etc.; If any of the above occurs, please make a detailed record and take a photo, and please contact us immediately. Precautions: Please handle gently when unpacking to avoid permanent damage to the products caused by bumps. Please do not use heavy tools or use rough methods to open them. Please do not discard all packaging materials for return shipments. 7.
N31 Linear Piezo Motor User Manual When cleaning the surface, try not to pick up the product. If it is necessary to pick up, please place a sponge under the product for protection, the product should not be too high from the sponge to prevent it from falling off. 8.Customer Service If you have questions about the products you are currently using, please let us know the following information: Product model number and related number. Controller model for this product.
