User Guide

Cloning and Tracing200
Use Obey Source Selection to paint in the area
that corresponds to the source selection.
Use Copy Source Selection to clone the
selection and the color.
To clone using the source
selection:
1 Set up a selection for the portion of
the source image you want to
clone.
The selection should closely
outline the region you want to use.
For information about setting up a
selection, refer to “Using
Selections” on page 203.
2 In the toolbox, choose the Brush
tool .
3 Choose a cloning brush from the
Brush selector bar.
4 On the Stroke Designer page of
the Brush Creator, choose
Cloning.
5 Choose a Clone Type from the
pop-up menu.
6 Enable the Obey Source Selection
option, the Copy Source Selection
option, or both.
7 Set source and destination
reference points.
Destination reference points can
be in the same or in a different file.
8 Click the Drawing Mode icon
in the bottom left corner of the
canvas, and choose Draw
Anywhere.
Setting the drawing mode to Draw
Anywhere is important. If you try
to clone while in another drawing
mode, your strokes will not reach
the canvas.
9 Paint in the destination.