Operation Manual

624 | CorelDRAW X8 User Guide
To Do the following
•Right — places the grommet markers along the right edge of the
page
Add grommet markers by specifying the space between them In the Placement and Distribution area, enable the Spacing
option, and type values in the Vertical and Horizontal boxes.
Working with a print service provider
When you send a file to a print service provider, the provider takes your file and converts it directly to film or to plates.
When you prepare a print job for printing, you can send camera-ready paper output or the work on disk. If you send the work on disk, the
print service provider needs either a PostScript file or a native file from the application that you use. If you are creating a file to send to an
imagesetter or a plate-setter, speak with the print service provider about the best file format and printing device settings to use. Always
provide a final printout of the work to the print service provider, even if it is only a black-and-white representation. This helps the print
service provider to identify and assess any potential problems.
Before printing a drawing, you must choose and properly configure the appropriate printing device driver. Consult the printing device
manufacturer instructions, or the print service provider or printing shop that you use to print the work, to find out the best way to set up the
printing device driver.
