Operation Manual

Working with layers | 263

To Do the following
Create a local layer In the upper-right corner of the Object manager docker, click the
flyout button , and click New layer.
Create a master layer for all pages In the upper-right corner of the Object manager docker, click the
flyout button , and click New master layer (all pages).
Create a master layer for odd pages In the upper-right corner of the Object manager docker, click the
flyout button , and click New master layer (odd pages).
This command is available only when the active page is an odd
page.
Create a master layer for even pages In the upper-right corner of the Object manager docker, click the
flyout button , and click New master layer (even pages).
This command is available only when the active page is an even
page.
To use a layer in the drawing, you must first make the layer active by clicking the layer name in the Object manager docker. The
layer name appears in a red bold font to indicate that it is the active layer. When you start a drawing, the default layer (Layer 1) is the
active layer.
Master layers are always added to the master page. Content added to these layers is visible on all pages of the document, all odd
pages, or all even pages, depending on the type of master layer that you have chosen.
Master layers for odd and even pages cannot be created in Facing Pages view. If you have created odd and even master pages before
switching to Facing Pages view, the odd and even master layers will be converted to all-page master layers. For more information
about facing pages, see “To view facing pages” on page 73.
You can also add a layer by clicking the New layer button in the Object manager docker.
You can also create new master layers by clicking the respective button in the Object manager docker: New master layer (all
pages) , New master layer (odd pages) , or New master layer (even pages) .
You can make any layer a master layer by right-clicking the layer name, and clicking Master (all pages), Master (odd pages), or
Master (even pages).
To make a layer active
1
If the Object manager docker is not open, click Window Object manager.
2 In the Object manager docker, click the layer name.
The layer name appears in a red bold font to indicate that it is the active layer.
By default, the active layer is Layer 1.
The name of the active layer and the type of the currently selected object appear on the status bar at the bottom of the application
window. The names of the active page and layer also appear at the top of the Object manager docker.