Specifications

5
The following screen should appear:
Figure 5. Login Screen
The factory default values are:
Username Leave blank
Password admin
Click OK.
The following screen should appear:
Figure 6. One Page Setup
By setting the parameters on this page, users should then be able to access the internet using the router.
• Host Name: This entry is required by certain ISPs. (If not necessary – leave blank).
• Domain Name: This entry is required by certain ISPs. (If not necessary – leave blank).
• Time Zone: Select the relevant time zone from the drop down list. (Setting this is optional)
• Private IP Address: This is the LAN IP address of the router. This is the address that is used to configure the router. The default values are:
192.168.1.1 for IP Address and
255.255.255.0 for Subnet Mask.
(Changing this factory default setting is optional, and is not necessary for most small networks).
• Wireless: Check “Disable” or “Enable” to make the wireless LAN function active. If you select “Disable”, then all of the following wireless parameters can be
ignored.
• SSID: (Service Set Identifier). SSID is the unique name shared among all clients and the router in a wireless network. The SSID must be identical for all wireless devices
and must not exceed 32 characters. The default value for the SSID is ‘corega’.
• SSID Broadcast: The router will broadcast the SSID to let wireless clients easily search and connect to this router. Default value is “allow”.
ENGLISH