ne | CO RECESS ; Far and Broad ‘ FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two .
1 Copyright| Copyright@ Co recess All Eights Reserved Na Part of this book sail bie reproduced, stored in a retrieval system. or transmitted by eny means, electronics, mechanical, photographing, recording, of otherwise, without written permission from the publisher The specifications and information regarding the products in this manual are subject to changed without niece.
i Introduction The Co recess 3113 is an Asymmetric Digital Subscriber Line (ADS) modem used for home connectivity Lo an ADS service provider network over an Ethernet network connection. The Co recess 313 ADS modem receives adaptive data rates of up to bps downstream and transmits 1 Bps upstream. . 1 Unpacking the Box Check the shipping carton carefully to ensure that the contents include the items you ordered.
LED Operation . 1 Configuring the TCP/IP When you have powered up the Co recess 3113, check the status of the four LED on the front pant th cloning table After you install the Co recess 3113, next is to configure the TCP/IP network protocol. Caution ; Wren you configure the TC PAP, Eave the default value of any other configuration that is nat mentioned in the following description. ; POWER ON | DC power is being supplied ta the Co recess 3113, : .
GEE 1. ~ w Click the Start bunion and select Settings 3 Network and Dial-up Connections. {Figure 1) 3 wee ie, 2} Figure 1 Right-click the Local Area Connection icon at the
SAIL] ® Click the Start button and select Run © The DOS-prompt appears. Input configure If you cannot connect to ADS network, please check the status of the LED on the front panel, release and press [Enter] key. and then ensure the following: 1 Troubleshooting 1. Check the LAN LED Hf the LAN LED goes off, ensure that the Ethernet cable is firmly connected both to the Ethernet port on the Co recess 3113 and LAN port on your PC. © Input configure renew and press (Enter key, 2.
