User manual

ColourPoint User Manual V1_2
10
DMX Operation
CORE ColourPoint is equipped with a Wireless Solution
W-DMX wireless radio receiver. This allows the fixture
colour to be set up by or synchronized with sequences
produced by a DMX lighting controller.
A compatible W-DMX transmitter attached to a DMX
controller is necessary, available separately. This could be
a lighting desk, a specific controller, or a CORE Point 15,
20 or 30 Master unit.
When in DMX mode the display will show the current active
DMX Start Address.
DMX
Addr: 001
The number of channels occupied is depends on the “DMX MODE” setting (4 or 5 channels may be
used by the fixture).
DMX Mode
The ColourPoint has 2 modes of operation.
From the “CHANGE Settings” menu select the “5
th
DMX CHANNEL” option as follows:
Mode
Chan
Function
Notes
5
th
CHAN
Off
1
Red
This mode disables master dimmer and
strobe functions. Each of the colour values
may be set from 0 to 255.
2
Green
3
Blue
4
White
5
th
CHAN
M.
Fader
1
Red
This mode enables the fixture’s overall colour,
set on channels 1 to 4, to be dimmed.
Values are 0 to 255, where 255 represents
100% output.
2
Green
3
Blue
4
White
5
Dimmer (0-100%)
5
th
CHAN
Strobe
1
Red
This mode enables the fixture’s overall colour,
set on channels 1 to 4, to be strobed.
Values are 0 to 255, where 255 represents 30Hz
strobing.
2
Green
3
Blue
4
White
5
Strobe (0-30Hz)
DMX Start Address
To set the DMX start address press key when the display shows the current address. Use the
keys to select the new start address then to confirm.