Specifications

5
Setup
• Do not switch on your CORD subwoofer until all connections are made.
• Connect the subwoofer out on your CORD mi-fi, source amplifier or receiver to the
 SUBINDIRECT on the subwoofer using a single RCA.
• If your source amplifier does not have a dedicated subwoofer out, connect the line
 outtotheLineIN on the subwoofer using a RCA cable, then connect your
speakers directly to the speaker out terminals  on the subwoofer.
• If your source amplifier does not have a dedicated subwoofer out or a line out, then
connect your speaker out from the source to the high level speaker in terminals ,
then connect your speakers to the speaker terminals  on the subwoofer.
• Ensurethevent is not covered or blocked.
• Connect the AC Power cable to the AC socket  and the AC wall socket.
SwitchofftheACPowerbeforeconnectingordisconnectingany
accessory cables to ensure correct operation.

Basicoperation
• ToturnONorOFF,movethemainPowerswitch totheONorOFFposition.
• To operate, turn the Operation switch  to On or Auto. Auto will permit the subwoofer
to enter a standby mode when no signal is received for a prolonged period.
• To increase the output level, turn the Level control  clockwise. To decrease the
volume turn the Level control counter clockwise. Adjust to remove any distortion.
• Toadjustthesubwooferphaseandachievetheoptimumsound,select0ºor180º
on the Phase selector .Normalsettingis0º.
• To adjust the crossover point or blend of sound between subwoofers and your other
speakers, adjust the Crossover selector .