Installation Guide

ManualsBrandsCorbett Lighting ManualsWall LightsCorbett Lighting Recoil 2 Light 13-1/2" High Wall Sconce with Metal Shade - ADA Compliant

FIXTURE PREPARATION

1. Remove the fixture and parts bag(s) from the carton.

NOTICE:

Before discarding the carton,

double check to make certain

that all parts are found.

191-12 2LTS. RECOIL SCONCE INSTALLATION INSTRUCTIONS

WARNING

DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE

READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.

NOTICE

· The important safeguards and instructions outlined on this sheet cannot

cover all possible conditions and situations that may occur. It must be

understood that common sense, caution and care factors that cannot be built

into any product. Caution and care must be supplied by the person(s)

installing, operating and caring of this lighting fixture.

· This fixture is design to be mounted on a correctly installed standard round

or octagon box or a through wiring box with a plaster frame. The box must be

securely mounted to the structure of the building. The crossbar and hardware

supplied should be used. Directly mounting the fixture to the outlet box may

make it impossible to correctly align the fixture.

FIXTURE INSTALLATION

1. Attach the crossbar to the outlet box.

(The green screw should face out).

2. Thread the hex nut onto the nipple

and the nipple into the crossbar.

Adjust the nipple so that 3/16 " of threads

extend beyond the back of the fixture. Lock

the hex nut against the crossbar.

CAUTION

· TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH

ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.

· INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR

CERTIFIED FACTORY TRAINED TECHNICIAN.

· If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.

DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.

In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead

A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.

Page 1 of 2

Outlet box

Green screw

Croosbar

Nipple

Hex nut

Cap nut

Light Bulb

L G H T N

Summary of content (2 pages)

PAGE 1
R L G H T N G 191-12 2LTS. RECOIL SCONCE INSTALLATION INSTRUCTIONS WARNING DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION. CAUTION · TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. · INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
PAGE 2
3. Fasten the ground wire to the green or bare copper wire in the outlet box (if outlet box is plastic) or to the green screw on the crossbar. WARNING Never fasten the ground wire to the black or "hot" wire! Failure to follow this instruction could result in serious injury or death! 4. Fasten the fixture lead with the ridge(s) to the white wire in the outlet box. Fasten the wires together with an approved fastener (wire nut).