Installation Guide
Page 1 of 2 120412ID
109-63 DOLCE INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached. DO NOT SEPARATE
ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular circumstances the BLACK
wire will be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead. A GREEN or BARE COPPER wire is the “Ground”. In
older buildings, it is always good practice to reconfirm the polarity of the wiring.
NOTICE
The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that may occur. It must be
understood that common sense, caution and care are factors that cannot be built into any product. Caution and care must be supplied by the
person(s) installing, operating and caring for this lighting fixture.
This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through wiring box with a plaster frame. The
box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used. Directly mounting the
fixture to the outlet box may make it impossible to correctly align the fixture.
INSTALLATION PREPARATION
1. Remove the fixture and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check the contents
to make certain that all parts are found.
FIXTURE INSTALLATION
1. Attach the adjustable crossbar to the outlet box.
(The green screw should face out.)
2. Start the studs into the mounting ring at the spacing
that matches the mounting holes in the fixture’s back.
3. Fasten the ground wire to the green or bare copper wire
in the outlet box (if outlet box is plastic) or the green screw
on the crossbar.
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in serious
injury or death!
4. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1" below the fastener, tightly wrap the connection
with electrical tape so that the tape seals the end of the fastener.
Crossbar
Lamp
End ball
Green screw
Outlet box
Stud
Sleeve