Installation Guide

ManualsBrandsCorbett Lighting ManualsCeiling LightsCorbett Lighting Dolce 4 Light 16" Wide Semi Flush Ceiling Fixture with Capiz Shell

Page 1 of 2 190412ID

109-34 4LT DOLCE SEMI-FLUSH INSTALLATION INSTRUCTIONS

WARNING

DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.

READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.

CAUTION

 TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL

ELECTRICAL/BUILDING CODES.

 INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.

 If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached. DO NOT SEPARATE

ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular circumstances the BLACK

wire will be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead. A GREEN or BARE COPPER wire is the “Ground”. In

older buildings, it is always good practice to reconfirm the polarity of the wiring.

NOTICE

 The important safeguards and instructions outlined on this sheet

cannot cover all possible conditions and situations that may occur.

It must be understood that common sense, caution and care are

factors that cannot be built into any product. Caution and care must

be supplied by the person(s) installing, operating and caring for

this lighting fixture.

 This fixture is designed to be mounted on a correctly installed

standard round or octagon box or a through wiring box with a

plaster frame. The box must be securely mounted to the structure

of the building. The crossbar and hardware supplied should be

used. Directly mounting the fixture to the outlet box may make it

impossible to correctly align the fixture.

INSTALLATION PREPARATION

1. Remove the fixture and parts bag(s) from the carton.

NOTICE:

Before discarding the carton, double check the contents

to make certain that all parts are found.

2. Remove the finial, trim frame and glass from the fixture.

FIXTURE INSTALLATION

1. Thread the studs into the crossbar at the correct spacing.

(The green screw is in the front). Attach the crossbar to the outlet box.

(The green screw should face the floor).

2. Adjust the studs so that they extend 3/16" beyond

the canopy of the fixture.

3. Fasten the ground wire to the green or bare copper wire in the outlet box

(if outlet box is plastic) or to the green screw on the crossbar.

WARNING

Never fasten the ground wire to the black or "hot" wire!

Failure to follow this instruction could result in

serious injury or death!

Outlet box

Green screw

Crossbar

End ball

Lamp

Stem

Capiz

Stud

Canopy

Summary of content (2 pages)

PAGE 1
09-34 4LT DOLCE SEMI-FLUSH INSTALLATION INSTRUCTIONS WARNING DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION. CAUTION  TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.  INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
PAGE 2
4. Fasten the white fixture lead to the white wire in the outlet box. Fasten the wires together with an approved fastener (wire nut) Starting about 1" below the fastener, tightly wrap the connection with electrical tape so that the tape seals the end of the fastener. electrical tape approved fastener (wire nut) WARNING Make sure that there is no exposed wire or strands that could cause a dangerous short circuit! 5. Connect the black fixture lead to the black wire in the outlet box.