User manual

19
ENGLISH
Drying sequence
Before starting up for the first time it is advisable
lo load a few moist cloths into the dryer and to
let it run for about 30 minutes. This ensures that
no dust and dirt is left in the drum. In order to do
this, switch the machine on by pressing the
ON/OFF button, set the programme selector dial
on “30”, then press the START button.
The programme will start and finish
automatically.
To dry your laundry:
1. Connect the tumble dryer.
2. Load the items one at a time, shaking them
out loosely and close the door.
3. Press the ON/OFF button (Marcha Parada),
the mains-on light lights up.
4. Select the required drying programme.
5. Press Low Temperature Button (Reducción
Temperatura) and/or Buzzer OFF Button
(Exclusión Alarma) if required.
6. Press the START-button (Arranque): the
selected programme will start and light
will illuminate.
P0885S
Arranque
Reducción
temperatura
Exclusión
alarma
PROGRAMAS
P0080S
Marcha
Parada
All the drying programmes end with a cooling
phase which lasts 10 minutes (the
corresponding light illuminates).
If the laundry is not removed at the end of the
programme, the machine will automatically
perform the anti-crease phase which lasts
about 30 minutes.
During this period the buzzer will sound every
10 seconds, unless you have depressed the
Buzzer Off Button (Exclusión Alarma). The
lights and flash alternately.
Turn the programme selector dial to “O”, switch
the machine off by depressing ON/OFF button
again and remove the laundry.
If this is not done, at the end of the anti-crease
phase the tumble dryer will automatically stop
functioning, light will flash and the Mains-On
light remains alight.
After each use
●●
Press the ON/OFF button again to switch the
dryer off. The mains-on light goes out.
●●
Turn the selector dial to “O”.
●●
Clean the fluff filter (see page 21).
125993090.qxd 7/2/02 11:33 AM Pagina 19 (Nero/Process Black pellicola)