Instruction manual

9-26
● Example of screen display
9.7.2 Logomark Brightness
The LOGO LEVEL is used to set the brightness of logomark.
The logomark can be displayed in four-grade monochrome data (LEVEL 3, LEVEL 2,
LEVEL 1, LEVEL 0 - in high to low). The brightness can be set for each grade.
This section only describes the setting procedure of LEVEL 3, however, the same
procedure can also be applied to LEVEL 2 to LEVEL 0.
● Settable Range
LEVEL 3: 040H (0%) to 3ACH (100%), 877 grades
The initial setting is 3ACH (100%).
LEVEL 2: 040H (0%) to 3ACH (100%), 877 grades
The initial setting is 288H (66%).
LEVEL 1: 040H (0%) to 3ACH (100%), 877 grades
The initial setting is 164H (33%).
LEVEL 0: 040H (0%) to 3ACH (100%), 877 grades
The initial setting is 040H (0%).
H : 0DOT / V : 0DOT H : 750DOT / V : 500DOT