Instruction manual

9-24
● Displaying Procedure of ID Character
9.7 Setting Logomark
The LOGO is used to set the logomark.
The logomark up to 320 (dot) x 240 (line) in QVGA(*1) size can be superimposed to the
SDI signal(*2). The logomark is converted from the 24-bit full color bit map to four-grade
monochrome data. No logomark is superimposed when the CHECK FIELD pattern is
selected. When converting the data into four-grade monochrome data, procure the
application software.
To display the logomark, transfer the data form the memory card to the main frame.
Create the "logo" folder on the memory card, then enter the file with arbitrary name (*. 1g)
underneath. Refer to Figure 9-1.
The logomark created with the LEADER LT 443D can also be used for the LT 4000.
Figure 9-1 Structure of logomark file.
Display the ID ON/OFF by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
v ＩＤ ＣＨＡＲＡＣＴＥＲ
２．ＩＤ ＣＨＡＲＡＣＴＥＲ
t ＩＤ ＯＮ／ＯＦＦ
３．ＩＤ ＯＮ／ＯＦＦ
■ＯＮ □ＯＦＦ
Display the ID CHARACTER by using the [5] and [6] keys.
２．ＩＤ ＣＨＡＲＡＣＴＥＲ
t ＩＤ ＯＮ／ＯＦＦ
Press the ENTER key. Press the MENU key to cancel.
Select the ON by using the [3] and [4] keys.
Select the OFF not to display the ID character.
Memory card
LOGO
logo1.lg
logo2.lg
logo3.lg
set_logo.txt