Instruction manual

9-18
9.6 Setting ID Character
The ID CHARACTER is used to set the ID character superimposed on the SDI signal.
No ID is superimposed when the CHECK FIELD pattern is selected.
9.6.1 Creating ID Character
The CHARACTER SET is used to create the ID character. Up to 20 alphanumeric
characters can be used for the ID character. To display the ID character, refer to Section
9.6.7, "Displaying ID Character" to select ON.
● Settable Range
The characters selectable from the space by pressing the [t] and [u] keys are shown
below. The initial setting is "LT 44003".
[t] key ！”＃＄％＆’（）＊＋，－．／０１２３４５６７８９：；＜＝＞？＠Ａ
ＢＣＤＥＦＧＨＩＪＫＬＭＮＯＰＱＲＳＴＵＶＷＸＹＺ［￥］＾＿→←
[u] key 3(*1)
● Setting Procedure of ID Character
*1 The background of 20-character area is displayed in black, however, the
background of each character is displayed in black when the [3] is entered at the
end of the character. When the [3] is entered between characters, the continued
characters are deleted. When other character is entered instead, the display
returns to the original conditions, however.
LT4400 LT44003
Display the CHARACTER SET by using the [5] and [6]
keys.
Press the ENTER key.
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
v ＩＤ ＣＨＡＲＡＣＴＥＲ
２．ＩＤ ＣＨＡＲＡＣＴＥＲ
u ＣＨＡＲＡＣＴＥＲ ＳＥＴ
３．ＣＨＡＲＡＣＴＥＲ ＳＥＴ
Ｌ
Ｔ４４００3
Display the ID CHARACTER by using the [5] and [6] keys.
２．ＩＤ ＣＨＡＲＡＣＴＥＲ
u ＣＨＡＲＡＣＴＥＲ ＳＥＴ
Press the ENTER key. Press the MENU key to cancel.
Move the cursor to the desired item by using the [3] and [4]
keys, then set the character by using the [5] and [6] keys.