Instruction manual

9-4
● Setting Procedure of Horizontal Timing
9.2.3 Horizontal Timing (Time)
The H-PHASE (μs) is used to set the horizontal timing in second. When the time is
changed, the horizontal timing set in Section 9.2.2, "Horizontal Timing (Dot)" is also
changed. The settable range depends on the format.
● Settable Range
Refer to Table 9-1. The step is about 0.0135 μs in HD format, 0.0370 μs in SD format.
● Setting Procedure of Horizontal Timing
Display the H-PHASE (DOT) by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
v ＴＩＭＩＮＧ
２．ＴＩＭＩＮＧ
v Ｈ－ＰＨＡＳＥ ［ＤＯＴ］
３．Ｈ－ＰＨＡＳＥ［ＤＯＴ］
ＳＤＩ ＋５ ＤＯＴ
Display the TIMING by using the [5] and [6] keys.
２．ＴＩＭＩＮＧ
v Ｈ－ＰＨＡＳＥ ［ＤＯＴ］
Press the ENTER key. Press the MENU key to cancel.
Sets the dot by using the [5] and [6] keys.
Display the H-PHASE (μs) by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
v ＴＩＭＩＮＧ
２．ＴＩＭＩＮＧ
t Ｈ－ＰＨＡＳＥ ［μｓ］
３．Ｈ－ＰＨＡＳＥ［μｓ］
ＳＤＩ ＋０．０１３５ μｓ
Display the TIMING by using the [5] and [6] keys.
２．ＴＩＭＩＮＧ
t Ｈ－ＰＨＡＳＥ ［μｓ］
Press the ENTER key. Press the MENU key to cancel.
Sets the time by using the [5] and [6] keys.