Instruction manual

9-3
● Setting Vertical Timing
9.2.2 Horizontal Timing (Dot)
The H-PHASE (DOT) is used to set the horizontal timing in dots. When the dot is
changed, the time set in Section 9.2.3, "Horizontal Timing (Time)" is also changed.
The settable range depends on the format.
● Settable Range
Refer to Table 9-1. The step is 1 dot.
Table 9-1 Horizontal timing settable range
Format H-PHASE (DOT) H-PHASE (μs)
1080i/60 ±2199 ±29.6161
1080i/59.94 ±2199 ±29.6457
1080i/50 ±2639 ±35.5420
1080p/30 ±2199 ±29.6161
1080p/29.97 ±2199 ±29.6457
1080p/25 ±2639 ±35.5420
1080p/24 ±2749 ±37.0235
1080p/23.98 ±2749 ±37.0605
1080PsF/24 ±2749 ±37.0235
1080PsF/23.98 ±2749 ±37.0605
720p/60 ±1649 ±22.2087
720p/59.94 ±1649 ±22.2309
720p/50 ±1979 ±26.6531
720p/30 ±3299 ±44.4309
720p/29.97 ±3299 ±44.4754
720p/25 ±3959 ±53.3198
720p/24 ±4124 ±55.5420
720p/23.98 ±4124 ±55.5976
525i/59.94 ±1715 ±63.5185
625i/50 ±1727 ±63.9629
Display the V-PHASE by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
v ＴＩＭＩＮＧ
２．ＴＩＭＩＮＧ
u Ｖ－ＰＨＡＳＥ
３．Ｖ－ＰＨＡＳＥ
ＳＤＩ ＋５ ＬＩＮＥ
Display the TIMING by using the [5] and [6] keys.
２．ＴＩＭＩＮＧ
u Ｖ－ＰＨＡＳＥ
Press the ENTER key. Press the MENU key to cancel.
Sets the line by using the [5] and [6] keys.