Instruction manual

9-2
9.1 Setting Format
The FORMAT SELECT is used to set the SDI signal format.
Refer to Table 4-1, "Format list" for the selectable formats.
● Format Selecting Procedure
This format can also be selected by using the FORMAT key.
Refer to Section 4.4, “Format Key”.
9.2 Setting Timing
The TIMING is used to set the SDI signal timing with respect to the internal reference
signal.
9.2.1 Vertical Timing.
The V-PHASE is used to set the vertical timing.
The settable range depends on the format.
● Settable Range
1080i, 1080p, 1080PsF: ±1124 lines, in 1 line steps
720p: ±749 lines, in 1 line steps
525i: ±524 lines, in 1 line steps
625i: ±624 lines, in 1 line steps
Display the FORMAT SELECT by using the [5] and [6]
Press the ENTER key.
１．ＳＤＩ ＳＥＴＴＩＮＧ
u ＦＯＲＭＡＴ ＳＥＬＥＣＴ
２．ＳＤＩ ＦＯＲＭＡＴ ＳＥＬＥＣＴ
v ５２５ｉ／５９．９４
２．ＳＤＩ ＦＯＲＭＡＴ ＳＥＬＥＣＴ
v ＊５２５ｉ／５９．９４
Press the ENTER key. Press the MENU key to cancel.
Select the format by using the [5] and [6] keys.
"*" is displayed before the selected format.