Instruction manual

8-5
● Setting Procedure of Horizontal Timing
8.2.4 Horizontal Timing (Time)
The H-PHASE (μs) is used to set the horizontal timing in second. When the time is
changed, the horizontal timing set in Section 8.2.3, "Horizontal Timing (Dot)" is also
changed. The settable range depends on the format.
● Settable Range
Refer to Table 8-1. The step is about 0.0135 μs in HD format, 0.0185 μs in SD format.
Display the TIMING by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key.
１．ＢＬＫ ＳＥＴＴＩＮＧ
u ＢＬＡＣＫ１，２ ＳＩＧＮＡＬ
２．ＢＬＡＣＫ１，２ ＳＩＧＮＡＬ
t ＴＩＭＩＮＧ
３．ＴＩＭＩＮＧ
v Ｈ－ＰＨＡＳＥ ［ＤＯＴ］
Display the signal to be set by using the [5] and [6] keys.
４．Ｈ－ＰＨＡＳＥ Ｒ：２．９９７Ｈｚ
ＢＬＫ１，２ ＋１０ ＤＯＴ
Press the ENTER key. Press the MENU key to cancel.
Display the H-PHASE (DOT) by using the [5] and [6] keys.
Sets the dot by using the [5] and [6] keys.
The internal reference signal is displayed at the upper-right
corner of the screen.
３．ＴＩＭＩＮＧ
v Ｈ－ＰＨＡＳＥ ［ＤＯＴ］
Press the ENTER key.