Instruction manual

7-7
● Selecting Procedure of GENLOCK Mode (MANUAL)
When MANUAL (GO INT) or MANUAL (STAYinSYNC) is selected in the genlock mode,
also the genlock format.
Table 7-1 lists the selectable genlock formats. The genlock format is expressed in the
number of total frame lines instead of the number of active picture lines.
Refer to Table 4-1, "Format Iist" for the REF.ID.
Table 7-1 List of Genlock format
1125i/60 750p/60 NTSC BB
1125i/59.94 (initial setting) 750p/59.94 NTSC BB+REF
1125i/50 750p/50 NTSC BB+ID
1125p/30 750p/30 NTSC BB+REF+ID
1125p/29.97 750p/29.97 525i/59.94
1125p/25 750p/25 525p/59.94
1125p/24 750p/24
PAL BB
1125p/23.98 750p/23.98
PAL BB+REF
1125PsF/24 625i/50
1125PsF/23.98 625p/50
7.3 Setting GENLOCK TIMING
The GENLOCK TIMING is used to set the analog black signal timing with respect to the
internal reference signal. There is a time lag to the output signal after the timing is set.
The timing is updated in a period of the internal reference signal. Two types of the
reference signals are provided: 2.997 Hz and 0.250 Hz. The genlock signal should be
applied for this setting. If there is no usable genlock signal, the following screen is
displayed.
Display the GENLOCK MODE by using the [5] and [6] keys.
Press the ENTER key.
Press the ENTER key. Press the MENU key to cancel.
１．ＧＬ ＳＥＴＴＩＮＧ
v ＧＥＮＬＯＣＫ ＭＯＤＥ ＳＥＴ
２．ＧＥＮＬＯＣＫ ＭＯＤＥ ＳＥＴ
v ＭＡＮＵＡＬ （ＧＯ ＩＮＴ）
３．ＭＡＮＵＡＬ （ＧＯ ＩＮＴ）
v ５２５ｉ／５９．９４
Display the GENLOCK MODE SET by using the [5] and [6]
keys.
３．ＭＡＮＵＡＬ （ＧＯ ＩＮＴ）
v ＊５２５ｉ／５９．９４
Press the ENTER key. Press the MENU key to cancel.
Display the GENLOCK FORMAT by using the [5] and [6]
keys.
"*" is displayed before the selected genlock format.
ＲＥＦ．（＝ＮＯ ＳＩＧＮＡＬ）
ＮＯＴ ＰＲＥＳＥＮＴ