Instruction manual

6-10
6.4 Ethernet Parameters Setup
The ETHERNET SET is used to set the Ethernet. The remote control status and genlock
status can be remotely monitored. (This function is not currently applicable for SNMP
user.)
6.4.1 Setting IP Address
The IP is used to set the IP address. To enable the settings, turn the power off, then
power on again.
● Setting Procedure of IP Address
Select OK by using the [3] and [4] keys.
When canceling, select CANSEL.
Press the ENTER key.
Press the ENTER key. Press the MENU key to cancel.
１．ＵＴＩＬＩＴＹ ＭＥＮＵ
v ＥＴＨＥＲＮＥＴ ＳＥＴ
２．ＥＴＨＥＲＮＥＴ ＳＥＴ
u ＩＰ ＡＤＤＲＥＳＳ
３．ＩＰ ＡＤＤＲＥＳＳ
ＩＰ：１９２
．１６８． ２０． ６３
ＩＰ：１９２．１６８． ２０． ６３
■ＯＫ □ＣＡＮＣＥＬ
Press the ENTER key.
２．ＥＴＨＥＲＮＥＴ ＳＥＴ
u ＩＰ ＡＤＤＲＥＳＳ
Press the ENTER key.
Display the ETHERNET SET by using the [5] and [6] keys.
Display the IP ADDRESS by using the [5] and [6] keys.
Move the cursor by using the [3] and [4] keys to select the
desired digit, then set the address by using the [5] and [6]
keys. The settable range is 0 to 255.