Instruction manual

4-9
b) Initialization
Initializes the software after removing the memory card to be upgraded.
Installs the memory card to be upgraded again after initialization is completed.
Refer to Section 4.8, "Initialization".
C) Upgrading the version of software and hardware (FPGA)
4 Confirming Version
Perform the procedure described in Step 1, "Confirming Version". Confirm that the
version is the same as the version displayed in Step 3, "Upgrading Version".
5 Initialization
Initialize this instrument, then confirm that the instrument correctly restarts.
To initialize this instrument, hold down the MENU and FORMAT keys simultaneously,
then turn the power on. Since all settings are initialized, apply the backup data as
required.
Refer to Section 4.8, "Initialization".
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
v ＦＰＧＡ－Ｖｅｒ ＊．＊ 4 ＊．＊
Press the［u］ key.
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
t ＵＰＤＡＴＥ
FPGA version is displayed.
Press the［u］ key
UPDATE screen is displayed.
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
u ＳＯＦＴ－Ｖｅｒ ＊．＊＊4＊．＊＊
The screen as shown in Figure left is displayed when the
memory card to be upgraded is connected.
Both of "*.**"
become the same version numbers.
２．ＵＰＤＡＴＥ
■ＯＫ □ＣＡＮＣＥＬ
Press the ENTER key
Select the OK by using the [
3] and [4] keys.
When canceling the upgrading, select CANSEL.
２．ＵＰＤＡＴＥ
■□□□□□□□□□□□□□□□□□□□
Upgrading is in progress. The INT and EXT LEDs in the
SYNCHRONIZATION group light alternately.
It takes about 10 minutes.
ＵＰＤＡＴＥ ＣＯＭＰＬＥＴＥ
ＰＵＳＨ ＡＮＹ ＫＥＹ ＳＴＡＲＴ
The screen as shown in left Figure is displayed when the
upgrade is completed
Press the ENTER key
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
u ＳＯＦＴ－Ｖｅｒ ＊．＊＊4＊．＊＊
Press any key.
The instrument automatically restarts. After the screen as
shown in left Figure is displayed, remove the memory card to
be upgraded.