Instruction manual

4-8
● Upgrading Procedure (When the current software version is ver1.65 and later)
● Upgrading Procedure (When the current software version is ver1.45 or previous)
Please upgrade in the following procedure.
a) Upgrading the software
Press the ENTER key.
ＣＦ ＯＰＥＲＡＴＩＯＮ
u ＣＦ Ｖｅｒ ＊．＊＊ 4 ４４００
＜ ＳＹＳＴＥＭ ＵＰＤＡＴＥ ＞
LDR ＣＯＰＹ．．．
1. SYSTEM VERSION UP
u SOFT－Ｖｅｒ ＊．＊＊ 4＊．＊＊
The screen as shown in Figure left is displayed when the
memory card to be upgraded is connected.
Upgrading is in progress. The INT and EXT LEDs in the
SYNCHRONIZATION group light alternately.
It takes about 3 minutes.
A
fter the version is upgraded, the instrument automatically
restarts. The software version that has been just upgraded is
displayed. Both of "*.**" become the same version numbers.
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
u ＳＯＦＴ－Ｖｅｒ ＊．＊＊4＊．＊＊
The software version is displayed when the memory card to be
upgraded is connected.
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
v ＦＰＧＡ－Ｖｅｒ ＊．＊ 4 ＊．＊
Press the [u] key.
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
t ＵＰＤＡＴＥ
２．ＵＰＤＡＴＥ
■ＯＫ □ＣＡＮＣＥＬ
FPGA version is displayed.
Press the [u] key
UPDATE screen is displayed.
Press the ENTER key
Select the OK by using the [3] and [4] keys.
When canceling the upgrading, select CANSEL.
２．ＵＰＤＡＴＥ
■□□□□□□□□□□□□□□□□□□□
Upgrading is in progress. The INT and EXT LEDs in the
SYNCHRONIZATION group light alternately. It takes about 10
minutes.
ＵＰＤＡＴＥ ＣＯＭＰＬＥＴＥ
ＰＵＳＨ ＡＮＹ ＫＥＹ ＳＴＡＲＴ
The screen as shown in left Figure is displayed when the
upgrade is completed.
Press the ENTER key
１．ＳＹＳＴＥＭ ＶＥＲＳＩＯＮ ＵＰ
u ＳＯＦＴ－Ｖｅｒ ＊．＊＊4＊．＊＊
Press any key
The instrument automatically restarts. After the screen as
shown in left Figure is displayed, remove the memory card to
be upgraded.