Instruction manual

4-4
*1 The SDI signal format can also be selected. Proceed as follows:
“SDI SETTING - SDI FORMAT SELECT"
Refer to Section 9.1, "Setting Format".
*2 The analog black signal format can also be selected. Proceed as follows:
“BLK SETTING - BLACK SIGNAL - BLACK FORMAT”
Refer to Section 8.1, "Setting Format".
2 Selecting Format
Select the format by using the
[t] and [u] keys. Table 4-1 lists the selectable format.
Pressing the ENTER key enters the format. The format is marked with asterisk (*).
Table 4-1 Format list
SDI BLACK
1080i/60
1080i/59.94 (initial setting)
1080i/50
1080p/30
1080p/29.97
1080p/25
1080p/24
1080p/23.98
1080PsF/24
1080PsF/23.98
720p/60
720p/59.94
720p/50
720p/30
720p/29.97
720p/25
720p/24
720p/23.98
525i/59.94 NTSC BB
625i/50
NTSC BB+REF（
*1）
NTSC BB+ID（*2）
NTSC BB+REF+ID
NTSC BB+SETUP
NTSC BB+S+REF
NTSC BB+S+ID
NTSC BB+S+R+ID
525i/59.94
525p/59.94
PAL BB
PAL BB+REF
625i/50
625p/50
*1 "REF" denotes the identification signal containing the following signals.
･The 714-mV reference signal is added to every 2 frames on the line 10. (NTSC)
･The 700-mV reference signal is added to every 4 frames on the line 7. (PAL)
*2 "ID" denotes the signal containing the ID signal conforming to SMPTE 318M
standards.