Instruction manual

4-3

3 ［MENU］key

This key is used to display the upper hierarchical layer.

The current layer number is displayed at the upper-left corner of the screen.

While displaying the setting screen, pressing the MENU key does not enter the current

settings; returns to the upper hierarchical layer by one.

On the top menu screen, pressing the MENU key sequentially selects the main menu.

Refer to Section 4.2, "Main Menu".

4 ［ENTER］key

This key is used to display the next lower hierarchical layer.

The current layer number is displayed at the upper-left corner of the screen.

While displaying the setting screen, pressing the ENTER key enters the current data,

then returns to the upper hierarchical layer by one. (*1)

*1: In some cases, the current settings may not be entered and the setting item is

marked with asterisk (*) even when this key is pressed.

4.4 Format Key

The FORMAT key is a shortcut key used to select the format of SDI SETTING and BLK

SETTING. Procedure is described below for selecting the format by using the FORMAT

key.

1 Selecting Signal

Press the FORMAT key to select the desired signal: "SDI" (*1), "BLACK 1, 2", "BLACK

3, 4," and "BLACK 5, 6" (*2).

Pressing the FORMAT key sequentially selects the signals as shown in Figure below.

１．ＵＴＩＬＩＴＹＭＥＮＵ

ＥＴＨＥＲＮＥＴＳＥＴ

２．ＥＴＨＥＲＮＥＴＳＥＴ

ＩＰ

２．ＥＴＨＥＲＮＥＴＳＥＴ

ＩＰ

１．ＵＴＩＬＩＴＹＭＥＮＵ

ＥＴＨＥＲＮＥＴＳＥＴ

２．ＫＥＹＬＯＣＫＳＥＴ

□ＯＮ ■ＯＦＦ

１．ＵＴＩＬＩＴＹＭＥＮＵ

ＫＥＹＬＯＣＫＳＥＴ

２．ＳＤＩＦＯＲＭＡＴＳＥＬＥＣＴ

v ＊１０８０ｉ／５９．９４

３．ＢＬＡＣＫ１，２ＦＯＲＭＡＴ

v ＊１０８０ｉ／５９．９４

３．ＢＬＡＣＫ３，４ＦＯＲＭＡＴ

v ＊１０８０ｉ／５９．９４

３．ＢＬＡＣＫ５，６ＦＯＲＭＡＴ

v ＊１０８０ｉ／５９．９４